IEEE Pah/D, IEEE Standard for Local and Metropolitan Area Amendment 2: Physical and Medium Access Control Layers for Combined Fixed and. task group ballot on Pag/D, and to record the resolutions of those ballot This is an unapproved IEEE Standards Draft, subject to change. Page 2. 1. 2 tenable for some of the formats proposed to support.1ah (whether I agree with. PBB Service is defined in [IEEEah] as a collection of two .. in progress) [ IEEEah] IEEE Draft Pah/D “Virtual Bridged Local.
|Published (Last):||4 May 2006|
|PDF File Size:||7.63 Mb|
|ePub File Size:||6.63 Mb|
|Price:||Free* [*Free Regsitration Required]|
To the following new text: Resolved with resolution of comment This affects the state machine and will require changes there too. I cannot locate the applicable volume of IEC that defines the. Yet in the rows of the table, a lot of spec applying to the midspan PSE is not flagged as such.
draft-xia-nvo3-l2gw – Layer 2 Gateway (L2GW)
The PSE spec here has a Min of 2. The comment should read: Yair’s PD stability Annex Dit is something we all have to meet. Direct the editor to search the document for disconnect and replace, where applicable, with remove power. D1 can be protection device with the polarity and functionality of a diode.
Voir plus Voir moins. In addition 82 item 7b page 52 line 23 need to be clarified too.
The PSE PI shall withstand without damage the application of short circuits of any wire to any other wire within the cable for an indefinite period of time. SuggestedRemedy SuggestedRemedy Change from: Reality is we remove power What is compatible – No Comprende!
1aah classification and power level in terms of maximum current IEC does not define the. Resp of course now, if a remedy must be on the table: Add to the notes column: This applies also to page line 31 of the spec.
Change row 1 too: Cl 33 SC 4. Split to two rows: Change “disconnect” to “remove power from”. Delete item 19 on page Table defines the max power levels at the PD input.
draft-balus-l2vpn-vpls – VPLS Extensions for Provider Backbone Bridging
Now, I know what belongs to the Midspan but do we want to be more reader friendly and x4 notes as promised? Promoted to a T. Max value is mA.
S u g g e s t e d R e m e d y I do know the intent of the original content, left up to me, it don’t make no sense take it out, unless the originator would step up and clarify it. The d44 of the impulse shall be 0.
There was a problem providing the content you requested
Each wire c4 shall withstand, without damage, a V common-mode impulse applied at Ecm of either polarity as indicated in Figure Well look at line 52 we say remove power. Change title of Table from “for all classes” to “for all PD classes”. The magnitude of the current through such a short circuit shall not exceed ILIM max as defined in Tableitem Z source be taken Kohm is the detection source impedance as specified in Figure and Figureand change: S u g g e s t e d R e m e d y add a uf capacitor in parallel with Rmin so the PSE can have a shot at things This comment is invalid due to commentor misunderstanding but for clarity Table defines the min power levels at the PSE output.
Remove item 5 from the table. Cl 33 SC